Differential repair? Hardeman Motorsport
Is your car making a whining, humming, or other unusual noise? Chances are the differential needs to be replaced. A commonly used solution for this problem is installing a second-hand differential. While this may temporarily solve the issue, the problem will likely return over time; moreover, there is a risk that it will not fit or that the final drive ratio is incorrect, preventing the car from functioning properly. A permanent solution is a differential rebuild with a 2-year warranty!
Why rebuild?
A rebuild ensures that your differential is as good as new again. All worn components are replaced so that your differential can last for many thousands of kilometres to come. During a rebuild, your differential is completely disassembled and all components are cleaned and inspected. All worn parts are replaced by us with new components. Next, your differential is reassembled and — crucially — set up to exact tolerances. The differential will once again operate smoothly and quietly for many years.
During a rebuild we replace all bearings, oil seals, and other gaskets/seals. Crown wheel and pinion gears are re-meshed and set up to factory specifications, or upon request to motorsport specifications. The exterior of the differential casing can be media-blasted and painted or powder-coated.
Can you hear underneath the car whether a differential is due for a rebuild?
Sometimes — especially in the early stages of bearing damage — it is difficult to notice, but there are a few things you can look out for.
Turn the input (pinion) flange by hand as shown in the video below. This should feel smooth; a slight amount of preload resistance is normal, but it should never feel as though there is grit or sand inside the bearings:
It can also be heard while rotating underneath the car. In that case, it sounds like the video below:
https://youtube.com/shorts/_p8UQArC2mk?feature=share
Standard 2-year* warranty
Because of our thorough build quality, you receive a 2-year warranty as standard. This means you do not have to worry about worn clutch plates, bearings, leaking oil seals, and similar issues often encountered with expensive second-hand units.

After the rebuild
Since the introduction of synthetic lubricants, many automotive manufacturers claim that differential oil never needs to be changed; yet the actual manufacturers of differentials and transmissions advise otherwise. We recommend changing the oil every 30,000 km (or with every engine oil service) to keep the differential in optimal condition.
On differentials that are not equipped with a drain plug from the factory, we can machine and fit a drain plug to make oil changes significantly easier.

We also recommend using Royal Purple Max Gear oil. Based on our specialisation in differentials, our experience shows that this oil guarantees the lowest possible wear.
For more information on differential oil, we have created a dedicated page: LSD and differential oil – Hardeman Motorsport
Wear?
Through years of experience, we have learned exactly where differentials wear, what their weak and strong points are, and where we can engineer improvements where possible. Not everything comes down to the oil alone, as extreme rotational speeds and friction place heavy mechanical stress on bearings, friction plates, and gear sets, leading to wear. The function of gear oil is to maintain a protective lubricating film that prevents metal-to-metal contact. Naturally, the better this film adheres to the metal surfaces, the better the protection will be. From hands-on experience, we have found a clear correlation between oil quality and differential wear.

Temperature
Royal Purple: with high-grade gear oil, the differential runs more smoothly, operating temperatures stay lower, and internal components such as clutch packs, bearings, and pressure rings last significantly longer. For example, Max Gear 75W140 proved itself in the M3 DTM, where a 40-degree temperature reduction was recorded following an LSD rebuild and the switch to this oil. Our own testing confirmed that Royal Purple Max Gear offers the best properties for differentials, prompting us to add it to our product range. Read more information about Royal Purple here
For additional thermal management — under motorsport conditions, for instance — we also offer further differential cooling solutions, such as cooling fins, high-capacity diff covers, and external oil cooler kits complete with pump and radiator.

Powder coating
Powder coating provides an extra durable protective layer against corrosion and external damage on the differential. We offer this service for cast-iron and cast-steel differential housings, carefully masking all machined mating surfaces and critical tolerances so only the intended exterior sections are coated.

Motorsport
Our background in motorsport has always enabled us to quickly identify the weak and strong points of any differential and determine which engineering solutions truly work. Furthermore, it has allowed us to master the finer details of limited-slip differential setup, making us your go-to specialist for advice, rebuilding, custom setup, and installation of an LSD in your differential.
Costs
Prices for a complete rebuild start at €600 depending on the differential type. You can also find pricing in our webshop at www.motorsportparts.nl. Of course, you are always welcome to contact us directly.
Interested in a differential rebuild? Request a quote now , send a WhatsApp message, or call +31113700266.

Special differentials and custom repairs
We also provide engineering solutions for specialist differential issues. You can turn to us for:
- Electronically controlled limited-slip differential faults and repairs
- Upgrading and reinforcing weak internal differential components, or parts that are no longer strong enough due to engine tuning
- Custom setup and rebuilding of limited-slip differentials, including bespoke motorsport applications
- Resolving excessive backlash/play or repairing damaged components.

Angle drive (bevel box) or PTO rebuild
Strictly speaking, an angle drive is not a differential, though the underlying engineering is very similar. These units consist of bearings, oil seals, a housing, and a hypoid crown wheel and pinion gear set designed to redirect power transmission through 90 degrees. They are commonly found on vehicles based on a transverse front-wheel-drive platform — with the engine mounted transversely at the front axle alongside the gearbox — that feature a power take-off to the rear axle for all-wheel drive.
That power take-off is the PTO (Power Take-Off) or angle drive / bevel box. This unit does not contain a differential itself because it does not need to split torque between two wheels.
We can rebuild many of these units and offer this service for a wide range of makes and models, including:
- Mini and BMW
- Audi (A3, S3, RS3, TT(RS))
- Skoda
- Seat
- Volkswagen
- Honda

Honda CR-V PTO
Beyond the differential alone:
A worn differential is one thing, but the surrounding driveline and suspension components age right along with it — and we are fully equipped to address them. We offer the following related components and services:
- Transfer case rebuilds
- Replacement of differential mounting bushes with rubber or polyurethane upgrades
- Custom modification and setup of limited-slip differentials
- Subframe refurbishment and reinforcement
- Wheel bearing replacement
- New driveshafts / halfshafts