E-diff, E-LSD, and Active M Differential are among the designations used for this type of limited-slip differential, which is fitted to many performance models. In most cases, the underlying engineering behind this type of LSD is identical, although calibration can vary substantially.

Operation:
Just like a viscous LSD and a mechanical clutch-type LSD, this differential uses a multi-plate clutch pack to limit slip and wheel speed differences between the left and right rear wheels. In this design, however, actuation is not mechanical and dependent on input torque or wheel slip, but driven by an electric motor. This electric actuator rotates two gears that run independently of the differential carrier via additional bearings positioned between the differential casing and these gears. By rotating these two parallel gears relative to one another, the mechanism reacts against the housing via a ball-ramp assembly. The further it ramps against the housing, the greater the clamping load applied to the clutch plates, and therefore the stronger the locking effect.

Application:
The advantage of this system is that the vehicle manufacturer can specify precisely when and to what degree the LSD is engaged. Using a series of discrete stages (typically around six), locking force is varied from fully open to a substantial degree of lock. The control unit determines the required locking level based on multiple sensor inputs, including throttle position, ABS wheel-speed data, steering angle, and the selected gear.
In practice:
In theory this sounds ideal, and Formula 1 also relies on electronically controlled differentials because they offer ultimate control over locking behaviour. In practice, however, we find that OEMs calibrate these systems very conservatively, resulting in a compromise in how the LSD performs. Manufacturers often restrict locking force in 1st gear to avoid excessive drivetrain stress, keep overall locking levels low to prevent clutch chatter or noise under all conditions, and use temperature sensors to monitor differential oil temperature—deactivating the LSD altogether as soon as it gets too hot.
Because of these interventions—and because a driver cannot anticipate every algorithm executed by the control unit—the differential behaves less predictably from behind the wheel, meaning factory-supplied E-diffs do not always deliver maximum performance.
Potential drawbacks include:
- Performance is heavily dependent on software calibration
- Higher part count, making the hardware more delicate
- Very expensive to replace and more complex to rebuild
- Not as consistent or dependable in operation as a purely mechanical LSD.
If you are experiencing faults or unusual noises from your electronic limited-slip differential, or if you find its on-limit performance lacking, please contact us to discuss the options for your car. We offer both specialist rebuilds and conversions to mechanical limited-slip differentials.