Hardeman Motorsport B.V. — Zandweg 20a, Kruiningen (NL) +31 (0)113 700266 info@hardemanmotorsport.nl

Oil Guide for Your Differential or Limited-Slip Differential

Differential oil is a vital factor in ensuring proper differential operation, particularly when dealing with a limited-slip differential (LSD). The guidance below applies to standalone differentials as well as front and rear axles. When selecting gearbox oil, it is advisable to stick to the viscosity grade specified by the manufacturer.

Oil for your differential or limited-slip differential — Cropped 1 0

Open (non-limited-slip) differential:

An open differential is the least sensitive to oil type. Provided the oil is clean and not overly thin, it will perform satisfactorily. We recommend a fully synthetic gear oil for optimal lubrication and durability—either 75W90 or 75W140. Oil containing an LSD additive is not required, though it certainly does no harm (aside from being slightly more expensive). In fact, an LSD additive will allow the differential to turn marginally more freely.

  • 75W-90 or 75W-140 (No LSD additive required, though permissible)
Oil for your differential or limited-slip differential — 01 1hju 43

Torsen limited-slip differential:

A Torsen LSD does not strictly require dedicated limited-slip differential oil, although on certain models an additive is necessary to keep operation noise-free. For this reason, we always recommend using gear oil with an LSD additive, even though the likelihood of an unloaded wheel spinning increases slightly due to the reduced internal friction. Preferably use 75W-140, as a Torsen unit can run quite hot.

Over time, a Torsen LSD will inevitably shed fine metallic wear particles, making it sensible to change the oil more frequently than vehicle manufacturers nowadays specify.

A Torsen LSD will generate slightly more locking effect when run on oil without an LSD additive, though gear friction (and wear) will increase somewhat as a result.

Oil for your differential or limited-slip differential — Hardeman Motorsport (3)
Failing to change the oil on time in a Torsen LSD allows steel wear particles to circulate through the differential and damage the gears.

Clutch-type LSD (Preload, Electronic or ZF type)

Under virtually all operating conditions, a clutch-type LSD requires genuine limited-slip differential oil containing an LSD additive (friction modifier). This silicone-based additive is formulated to allow the clutch plates and friction surfaces to slip smoothly against one another, enabling the LSD to lock progressively without chatter or jerking. Insufficient or degraded additive (caused by excessive differential temperatures) results in an unruly car during cornering that chatters, groans, clunks, or jerks. If your vehicle exhibits these symptoms, it is essential to replace the differential oil promptly to prevent further mechanical damage.

Over time, a clutch-type LSD will always generate some wear debris from its friction discs, so changing the oil more frequently than modern manufacturer schedules suggest is well advised.

  • 75W-140 or 80W-250 (With LSD additive!)
  • Pure LSD additive (useful if your gear oil lacks sufficient friction modifier or if you want smoother LSD engagement; incidentally, it also helps other mechanical assemblies run more smoothly)
Oil for your differential or limited-slip differential — Hardeman Motorsport (4)
On a clutch-type LSD, such as this unit from a Jaguar F-Type, an LSD additive is essential.

Viscous limited-slip differential:

A true viscous LSD—not a shear-pump-actuated clutch-type LSD as fitted to the E46 M3, Z4M, E60 M5, E62 M6, E90 M3, and 1M Coupé (for those, refer to the clutch-type LSD section)—features a separate sealed chamber filled with high-viscosity fluid in which the viscous plates rotate, while the remainder of the unit essentially operates as an open differential from an oil standpoint. Consequently, it uses the same gear oil as an open differential and does not require an LSD additive.

  • 75W-90 or 75W-140 (No LSD additive required, though permissible)
  • High-viscosity fluid (Available on request, depending on application)
Oil for your differential or limited-slip differential — Hardeman Motorsport (5)

Oil capacity:

Differentials and rear axles rely on the internal geometry of the casing and rear cover to distribute gear oil effectively, and each unit is engineered around a specific oil level. As the crown wheel rotates through the sump, it picks up oil and slings it throughout the housing. Contoured internal surfaces and oil drainage channels then direct oil to all bearings without foaming. Aftermarket modifications such as coolers or alternative covers can disrupt this flow path and cause the oil to foam, preventing it from lubricating properly.

An excessively high oil level can likewise create unnecessary parasitic drag and pressure inside the differential. We therefore advise careful consideration before making modifications, and caution against overfilling the differential. With the differential installed in the car and the vehicle standing level, you can fill the differential until oil begins to trickle out of the filler hole (in almost all cases, this is the standard operating level). Slightly too much or too little oil is generally not critical.

  • Standalone differential: typically between 1 and 2 litres capacity
  • Live / solid axles: between 1.5 and 3 litres capacity
Oil for your differential or limited-slip differential — Hardeman Motorsport (6)
Gear tooth wear inside a differential is virtually non-existent unless the unit has been run low on oil or on poor-quality lubricant. A low oil level causes the differential to overheat and burn the oil; lubrication breaks down and the gears eventually friction-weld themselves together.

Motorsport:

For motorsport use, we recommend running a heavier-viscosity gear oil such as OS 250R 80W-250, as thicker oils withstand higher operating temperatures. However, when using an external cooler with pump, oil selection depends on whether a thermostat is fitted. Excessively thick oil can overload the pump and cause premature failure. A thermostat ensures that the pump only operates once the oil has warmed up and thinned out. Without a thermostat, it is preferable to use 75W-90.

Oil for your differential or limited-slip differential — Hardeman Motorsport (7)
Hardeman external differential oil cooler kit. Increased oil capacity and active cooling extend oil life, resulting in superior cooling performance and a more durable differential.

Off-road:

In off-road use—especially when driving through puddles and mud—there is a risk of water and contaminants entering the differential via the breather vent. A small amount of moisture is not an issue, as a sustained drive will boil it out again, whereas mud and debris cake inside the housing and trap moisture, eventually causing internal corrosion or bearing and gear damage. Always inspect the differential oil after driving through deep water or mud. Many 4×4 models are equipped with an extended hose on the breather vent to prevent water ingress under normal circumstances.

However, when a hot differential enters cold water, it cools rapidly and pulls a slight vacuum, allowing water or debris to be drawn inside past an oil seal or gasket gap.

Oil for your differential or limited-slip differential — 100 1071
When contamination reaches this stage, the differential should be thoroughly cleaned with degreaser, flushed out, and only then refilled with fresh gear oil.

Service interval:

Road use:
Follow the manufacturer’s scheduled interval, or every 60,000 km in the case of lifetime-fill oil.

Fast road and LSD:
Between 25,000 and 50,000 km, or every two years. If the limited-slip differential starts making noise, change the oil. After an intensive trackday season, changing the oil every six months is advisable.

Motorsport:
Every six to twelve months.

Whenever in doubt, it is advisable to draw a small oil sample from the differential for inspection. If it smells burnt and/or contains heavy contamination (such as metallic shimmer), it is time to replace the oil.

Need advice or a quote for your differential or chassis?

Send us your VIN and intended use for a tailored workshop quote, or order parts directly at Motorsportparts.nl.